Does this help you with the adjustment?
http://www.buicks.net/shop/reference...djustment.html
Hello everyone,
Thanks Judd for sending the picture.I have the timing chain and sprockets on exactly as shown in the photo.I hope I got top dead center correct.
I don't think I put the distributor in exactly right.It's pointing near #1,what happens if it's not exact?
Is there a trick to getting the rocker arm shafts on properly?When I begin tightening bolts some of the push rods offer resistance.Am I supposed to rotate the cam or crank while I tighten down the bolts that hold the rocker assembly on,or do I just apply pressure and tighten them down?
neandertal
Does this help you with the adjustment?
http://www.buicks.net/shop/reference...djustment.html
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Hello bob,
Apparently I have the non adjustable type.Yippee.
Thanks for the response.
iddie [img]graemlins/hurray.gif[/img]
Bookmarks