Only the 322 manifold will fit with no modifications, same basic block.
Ok.......I believe I asked this question before but need to ask again as I can not find the answer..........will a manifold for 322 or 364 nailhead fit the 264 Nailhead???
Please.......
Help.....
Me.........
Bob
Only the 322 manifold will fit with no modifications, same basic block.
If something is listed for the 322 & 364 nailhead then it will not fit the 264, or will it?
Or is the person who listed it incorrect
Bob
ok....the manifold I am looking at has the following numbers, 3413, on the bottom....does anyone have a cross over chart? I am trying to figure out if it fits the 322 or the 364...if it fits the 322 it will fit my 264 right?
Bob
The 264 & 322 share the same intakes. The 364 DOES NOT.
Tom T.
allthough 264 isn't mentioned, the chart at the bottom of this page may help with identification.
If you would llike to place an image of your car in your signature, click here for instructionsWEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Offy # 3413 = 3x2bbl '53-56 264-322
3557 = 3x2bbl '57-59 364
5190 = 3x2bbl '59-66 401-425
This is for the 264-322 ....lucky ******* LOL
Good luck
The difficulty is not solving the problem. The difficulty is determining the correct problem to solve!
Hey Bob
Lucky for You
Your looking a the correct manifold for that '55 of yours.
Regards,
Tom Gallagher
Thanking YOU, for YOUR Valued Cooperation and Experience in This Matter.
NOSTALGIA Is A DEVICE That REMOVES The RUTS and POTHOLES From MEMORY LANE.
Tom Gallagher (BUICK BANSHEE)
1956 Buick Special 2 Door H/Top 46R: Red & White
Darlington Station, RI. 02861
Bookmarks