Ok so i have new whoopdeedoo rollermaster billet 9 keyway timing set, however when i line the marks up for straight up the teeth are off compared to my old set if i set it a 6+ than it lines up the same as my old set at straight up. my buick performance book makes mention of this problem but says i only need 4+ to make it correct. I am going to get a stock set and see how it lines up so ill at least have a baseline, but i seem to remember somebody telling me stock set are made 4-. any help or info would be super
Don
I ran into that same situation and read the same information. I was lucky enough that I was using a degree wheel to set it up, so I just ignored the numbers and found the key that gave me what I was happy with. I don't remember which slot that was.
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Bookmarks