You can tap it in until it is flat with the surface. Tap lightly.
How do I best install the inside wheel bearing seal on the one piece rotor and hub, does the seal need to be pressed in or can it be tapped in with block and mallet? Suggestions?
You can tap it in until it is flat with the surface. Tap lightly.
86 GN, all factory options, engine build in progress
72 Skylark Convertible, 462, TH 400
72 GSX Clone 464, TH400, 3:42. 10.71 @126mph best
We build GM carburetors and specialize in custom built Quadrajets
www.quadrajetpower.com
mark@quadrajetpower.com
tapped in and back on the road, thanks
Bookmarks