Thanks for replys, I decided to scrap both and go with TA double groove teflon coated. Thanks to all
What to do? use coated with grooved backside cam bearings or TA double grooved not coated. My mains and rods are coated. Engine will be run 6000-6500 RPM with solid lifters
Thanks for replys, I decided to scrap both and go with TA double groove teflon coated. Thanks to all
I looked at your posting, but I am unaware of what "coating" was.
I used the TA ones.
If you would llike to place an image of your car in your signature, click here for instructionsWEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Bookmarks