Thanks Bob, Appreciate your response,
Thanks ogog, I would have stayed with the original set up but unfortunately the conversion to rhd looks a little messy with steel rods running across the inside of the dash to make the auto column linkage to the gearbox work. Floor change will be much...
Thanks for the info, ofog,
Very much appreciated.
Do you know where I might source a relatively good complete steering column by chance; I'm wanting to change it to a floor auto so wouldn't need the selector on the column. Any thoughts appreciated....
Thanks Larry, very much appreciate you clarifying that for me. Would you know what the measurements are for the original steering column by chance so I know which length I require for a refit?
Hi there Team, Hope all is well in your part of the world. I sourced a HQ power steering box for the buick but now looking to source a complete (new) steering column as the one in the car was cut short for the conversion!! which is illegal here in NZ. Ive hunted high and low to get the...
Hi there, I have a 1973 Buick Centurion 4 door sedan (A body) that I'm converting to rhd as current link isn't compliant.. The current conversion consisted of the column on the right handside then a steering bar running left across the firewall to meet up with the shaft to the steering box on...
Hi Team,
I have a 73 Buick Centurion 4 door hardtop that I brought with me to NZ from Australia.
My car is right hand drive however, when it was converted, they ran a bar type arrangement (chain and cog setup) across the firewall linking into the steering arm and steering box which is located...
Hi Team,
I have a 73 Buick Centurion 4 door hardtop that I brought with me to NZ from Australia.
My car is right hand drive however, when it was converted, they ran a bar type arrangement (chain and cog setup) across the firewall linking into the steering arm and steering box which is located...
73 Buick submitted a new listing:
73 Buick Centurion rhd steering box and associated parts requests - 73 Buick Centurion rhd steering box and associated parts requests
Learn more about this listing...
Hi Team, Im just putting the 455 back in the car but note there are 2 front and 2 back holes on the intake manifold. Can anyone please tell me if there are plugs to block these off or should these have hoses connected? If the klatter from where
Appreciate your advice.
Cheers
Jim
Perth Australia
A new Wanted listing has been posted by 73 Buick:
73 Buick Centurion
The description for this listing is:
--------------------------------------------------------------
Hi Team, I have a 73 Buick Centurion and am wanting a front left Parklight/Turn Signal Lens or complete Unit......(Its the...