Here's a shop manual on ebay right now!
CLICK HERE!
Good luck
1957 Nailhead all apart
I have disasembaled my engine. I have found this number on the main bearing M M400 then right below 8944. Is this a stock crank shaft or has it been turned down. Also rod bearing number is 8943 and GM M400.
The crankshaft # 1173341.
I need a motor manual for this engine. So I can get all the specification.
Ron
Here's a shop manual on ebay right now!
CLICK HERE!
Good luck
If you would llike to place an image of your car in your signature, click here for instructions
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Junior Member
These Are Probably The Orig Brgs. As That Is The Id On All Original Gm Main Brgs. Also No One Ever Made An Aftermarket Crank. This Engine Has Most Likely Neve Been Apart. Heres An Inportant Tip.... When Rebuilding Make Sure To Use A Rubber Rear Seal For The Rear Main . Contact Best Gasket Co In L.a. Calif. For This And Whole Gaskeet Set @888-3332378. Have Fun, Alan
Members who have read this thread: 0
Posting Permissions
Bookmarks