i'm not sure if i understand your question totally, but it seems to me that the belts should pass between the seat cushion and the seat back. the belts should be anchored to the floor, using fender washers on the underside of the floor.
I am putting in front seat belts, lap only as Daisy is pillarless. Safety before anything else, I dont mind doing any minor mods to the seat to allow the belts to do thier job properly. I am finding it a difficult process exactly how to pass the belt through the base of the seat frame. Other than making an opening through the base, I cannot see another way...Does anyone have any ideas ?? Has anyone done this ??
Carpe Diem...and drive my '57 Riviera Special....
i'm not sure if i understand your question totally, but it seems to me that the belts should pass between the seat cushion and the seat back. the belts should be anchored to the floor, using fender washers on the underside of the floor.
Hi Noel,
heidigirl is right.
I purchased my belts at ANDOVER RESTRAINTS, INC.
They have a website and they give installation instructions. I guess, this applies for you:
http://www.andoauto.com/instruction2.htm
Best regards
Kindacool
A bad solution is applicable to almost every problem !
Bookmarks