Searched hi & lo at a salvage yard today, looking for 1968 GS windshield pillar trim pads and trunk lid support rods. No 68 GS's or Skylarks there, but found 68 Cutlass with very good pillar trim pads, and trunk rods. Unfortunately the rods are not the same, but the trim pads look identical, haven't attached them yet to be sure. Question is, on the back of the trim pads, the "liner" is not very good, and the metal has surface rust, so should I remove the liner, clean up the rust, and replace the lining with something else? Maybe a thin layer of foam rubber type padding? Also, any ideas on a supplier for the trunk lid support rods? I haven't seen them in any catalogs.