Results 1 to 3 of 3

Thread: Jonezt1947

  1. #1
    Join Date
    Nov 2018
    Location
    hamilton
    Posts
    2
    Rep Power
    0

    Jonezt1947

    Engine in my classic wooden boat is a Buick 401 nailhead. However the distributor is mounted on the front of the block instead of the rear. Engine casting number is 134-9046 which indicates the 401 nail head motor. When I look up firing orders for this engine they The show they distributor mounted on the rear of the block. Firing order on the valve covers 12784563. Is this the correct firing order? And what is the number one cylinder? Is the firing order the same weather they distributor is mounted on the front or the rear of the block?

  2. #2
    That is the correct firing order for a Nailhead. The block casting number appears correct, however the Nailhead distributor is mounted on the back of the block.

    I don't suppose the boat has a V-drive which would mount the engine backwards?

    Buick firing wiring and firing orders here; https://www.teambuick.com/reference/...ine_firing.php


    WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
    Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!

  3. #3
    However the distributor is mounted on the front of the block instead of the rear.

    unpossible. Buick *never* made a Nailhead with the distributor at the "front" of the block. the 215ci and 300ci had valve covers stamped to resemble those on a Nailhead but they are NOT "Nailhead" engines. they are what is considered "Small Block Buick" designs and there are significant architectural differences between a SBB and a Nail.

    remember, for our purposes the 'front' of the block is where the fan / timing cover is located, regardless of how the engine is oriented in hull. so, as Bob says, verify that the transmission bell housing has not been oriented towards the bow.

    of course, the quickest way to differentiate the designs is that the Starboard side cylinder bank ( like a Pontiac ) is the forward bank on a Nailhead while it's the Port ( or "driver's side" in a car ) side cylinder bank that is forward on most other GM engines. and it doesn't matter how you rotate the engine on a vertical axis, this will always be true.

    turning a Nail around 180 degrees will mean that while mounted in a car the #1 cylinder would have been furthest forward on the passenger ( or Starboard ) side, your boat "reverse mount" placement would put the #1 cylinder as the rear most cylinder on the Port side.

    IF this is a SBB, then the engine is in the normal timing cover to the front orientation and the #1 cylinder will be the forward most cylinder on the Port side.

    https://www.teambuick.com/reference/...ine_firing.php
    The way to crush the bourgeoisie is to grind them between the millstones of taxation and inflation.
    Vladimir Lenin

    Government schooling is about "the perfect organization of the hive."
    H.H. Goddard, Human Efficiency (1920)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
TeamBuick.com Privacy Policy