The chassis manual specs are in the Buick 300, 340 Engine Specifications above, but they are extreme. You would not want to be tighter than .0015" and hopefully not wider than about .0025".
Okay, so I’ve got my 300 all machined up now and I’m ready to start reassembly. Does anyone know or have a good guide as to what my bearing clearances should be with everything torqued up.
Thanks in advance
Sent from my iPhone using Tapatalk
The chassis manual specs are in the Buick 300, 340 Engine Specifications above, but they are extreme. You would not want to be tighter than .0015" and hopefully not wider than about .0025".
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Bookmarks