First: Engine idle rpm should be at appx 500, high idle speed causes a harsh engagement.
2nd: rear trans mount and thrust pads may be torn or seperated, they must be in good shape.
3rd: engine motor mounts may be bad or seperated/broken. ....John
Hallo
sorry for my english but im italian
have a Buick special 56 whit dynaflow den run god
the problem is when clutch reverse gear make a very noise "clunch" and the car snaps back ..
have you a advice?
Very tanks 👍
First: Engine idle rpm should be at appx 500, high idle speed causes a harsh engagement.
2nd: rear trans mount and thrust pads may be torn or seperated, they must be in good shape.
3rd: engine motor mounts may be bad or seperated/broken. ....John
tanks to texasjohn55
I think the problem is the 2nd solution because they are in bad condition...
you recommend me a seller who can send me right parts ?
i have contact bell Buick parts but its very expensive...
i also need other parts... ( right arm rest, oil pan gasket,pan transmission gasket, front timing cover gasket set, engine valve cover gasket, transmission thrust pad, dynaflow mount transmission, fuel pump rebuilding kit, external mirror, engine oil filter, kit engine distributor whit cup, rotor, ignition point, dome lamp complete, carburetor kit for stromberg 2 barrel)
thanks to those who help me
www.rockauto.com
www.oldbuickparts.com
www.kanter.com
www.autotran.us
www.fusickautomotiveproducts.com
I don't know if they ship to Italy, you will need to check that. You can also buy Shop Manual on CD, YOU WILL NEED ONE.
Shop wisely, some prices vary.........................John
Last edited by TexasJohn55; 02-10-2017 at 07:49 AM.
Bookmarks