stalling

[LODENAQU]

I just had my 72 Skylark tuned up, when I start it and put it in gear it makes popping noise and stalls, I restart and let it run a for a few minutes and it will finally go. Once it is warmed up in runs great. What causes this stalling problem? 350, Edelbrock 4 brl
E-TRON D106PS Ignition Breaker Points

E-TRON D204 Condenser / Capacitor
E-TRON D426R Distributor Rotor
E-TRON D668 Voltage Regulator

I just don't remember what causes these problems, getting old.

[Interceptor 55]

It appears you may have two problems. Your warm up problem might be a sticking/ malfunctioning choke. You want to see the position of the choke with the air cleaner removed before starting and after running for a few minutes to see if it is sticking. Your tune-up wasn't very clearly explained. What did you do? Did you change points? Are they adjusted correctly? How about the fuel.? (How old is the fuel? ).
These are just of a couple things that may cause your problems.

I hope this helps.
Take Care