Hello all My project in coming along nicely!
Currently the 320 is almost finished on the rebuild
I am having difficulty disassembling the rocer shaft for a good cleaning
The whole engine was taken down and hot tanked, plus a good steam cleaning after all machien work was complete
The rocker shaft has 70 years of oil sludge and crap in it
These need taken down and cleaned before it goes back together
This is the final step before I lash the valves and build a fire in her!
This good old engine should make my auburn replica fly!
Thanks guys
Dave
Here is some guidance near the bottom of the page:
http://www.teambuick.com/reference/l.../files/2-d.pdf
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Bookmarks