Assuming our chart is correct, there shouldn't be a problem, in fact they should be a nicer set.
http://www.teambuick.com/forums/view...bers_big_block
Existing head casting # is 1231109 out of a 69 Riviera 430 are found to be cracked, just got a pair out of a salvage yard from a 68 430, head casting # 1382985. I need feedback to know if they are compatible before I move FWD on the rebuild. There are some variations that I see and it seems there is 1 less water jacket hole.
Appreciate any comments or info
Thanks,
Richard
Assuming our chart is correct, there shouldn't be a problem, in fact they should be a nicer set.
http://www.teambuick.com/forums/view...bers_big_block
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Thanks for your time Bob, confirming what I was hoping. I'm under alot of pressure over here, if its not one thing its another with this project. Although it is very rewarding. I was just out cleaning them up , pulling the valves and I noticed that both intake and exhaust valve guides have seals. My original head had seals for the intakes only as the exhaust guides were taller.
Richard
That means the have probably been worked on as the 430 only had intake seals.
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
Bookmarks