Hi,
well, being from Germany, I am not sure if the hole in the case that takes the shaft is correctly referred to as a "bearing", too. It is not an actual bearing, sure, but is serves as a bearing and therefore has to be clean and smooth. That is what I meant...
A bad solution is applicable to almost every problem !
Sir, when asking for help on these forums, you may not get a direct answer to your problems. You may get something that might indirectly help, or direct you to where some help can be found. There are many ways carburetion can be diagnosed, when, gurgling, putting, and choke seizing, then ending with a big bang. Sometimes, a person will send helpful hints if they don,t have a direct answer and will, instead find something that helps anyone reading with similar problems.
Bookmarks