I'm pretty sure they do. To get valve seals you'll need to buy them seperately.
Hello
Could anyone tell me if the heads on a 1964 300 have seals on the valve stems , I have two sets and one has them and one does not and the rebuild gasket kit does not have them ?
thanks
I'm pretty sure they do. To get valve seals you'll need to buy them seperately.
Hello Junior
Thanks for the response . i took the heads to my engine rebuilder and he said that there is not enoght room on the stem to accept a regular cup seal and that they use o rings or machine the guide down to accept a proper seal . i have used a o ring that he gave me and will try that
thanks again
HELLO EVERYBODY,
I AM NEW, AND FRENCH, I LIVE NEAR LE MANS, (24 hours OF LE MANS), AND I POSSESS A BUICK SKYLARK64 HARDTOP IN THE COURSE OF RESTORATION(CATERING)...
I AM ON THIS FORUM TO HAVE INFORMATION AND SHARE.
PS: SADDEN MY ENGLAIS AND BAD
Is no problem. Your English is far better than my French.
The way to crush the bourgeoisie is to grind them between the millstones of taxation and inflation.
Vladimir Lenin
Government schooling is about "the perfect organization of the hive."
H.H. Goddard, Human Efficiency (1920)
gotta ask a question: are you SURE that set of heads do not have valve
seats/seals.
I lost one while installing new valves, took a Buick Team member in California to offer me "just one" pair - otherwise I'dda had to buy a complete set: 16 pair....
Thanks again Eric
Butch
It has been a long time since I rebuilt a 300 but seems like I remember them using the o-ring type seals.... I have also in the past used the soft neoprene umbrella seals on them from a ford engine.....
OK, thank you for the tip
Bookmarks