From the Reference Section:
- Carter Dual 4-Barrel Carburetor Idle Adjustment
- Carter Dual 4-Barrel Carburetor Adjustment
- Carter Dual 4-barrel Carburetors, Linkage Sticking
- Buick Cam Specifications for 401 and 425 nailheads
- Buick Cams from Kenne Bell, 401, 425
    - Nailhead Engine Specifications
- Head Flow Chart
- Nailhead Oil Pump
- Nailhead cam specs and cam selection
- Nailhead Parts Interchange
Results 1 to 2 of 2

Thread: 1950 - I Need NOS Cylinder head and specs for 263 Super 50 Dynaflow str8

  1. #1

    1950 - I Need NOS Cylinder head and specs for 263 Super 50 Dynaflow str8

    I'm rebuilting a 263 str 8 engine #57682065 for a 1950 Buick Super Eight 50 with Dynaflow VIN#5551918

    I need a NOS (or used in very good condition) Cylinder Head: can someone tell me where I can find it?

    I need also engine specifications to identify :
    - Piston Ring Size
    - Connecting Rod Bearings Size
    - Main Bearing Size

    Thanks!

  2. #2
    Here are all the specs for a 263 out of the '52 shop manual that is in the reference section:
    http://www.teambuick.com/reference/l.../files/2-a.pdf

    This fellow would sell you a head: http://www.teambuick.com/classifieds...ct/5329/cat/53
    Last edited by Bob; 12-06-2010 at 07:24 AM.


    WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
    Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!

Similar Threads

  1. Cross-flow/OHC head for str8
    By onetruerick in forum Straight Eights!
    Replies: 99
    Last Post: 10-30-2011, 05:42 PM
  2. str8 HI-PERF Head
    By alleycat in forum Straight Eights!
    Replies: 3
    Last Post: 01-02-2007, 06:00 PM
  3. '71 350 cam specs /head flow
    By Nightwrencher in forum Small Block 215, 300, 340 (and Rover V-8)
    Replies: 0
    Last Post: 04-20-2006, 03:21 AM
  4. 1950 Straight 8 Head torque specs?
    By Shan in forum Straight Eights!
    Replies: 3
    Last Post: 02-20-2005, 09:16 PM
  5. milling specs for cylinder heads
    By Anotherbrand in forum Big Block: 400, 430, 455
    Replies: 2
    Last Post: 07-25-2004, 12:53 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
TeamBuick.com Privacy Policy