Hey guys, I am in the process of breathing life back into my '71 Skylark. Ten years ago, I replaced the frame with a '69 (?) Chevelle frame. The '71 Frame had Delco-Moraine brakes (well, at least wheel cylinders), and the '69 has Lockheed-Wagner Cylinders. Also, the drums on the '69 unit are smaller, and the pinion yoke is a 27-spline unit, while the '71 was a 31 or so unit. I never had the ebrake cable hooked up to it, because the cable I had was too long! The Year One catalog seems to show that the '69-'72 cables are the same length. Some other catalogs show that '68-'72 are the same length. Is it possible that I have a brake/rear end/setup for a '68? I can't tell you if the car has round or oval bushings up front, considering I am out of the country right now... Any ideas?

Question #2: Will the clutch/brake pedal assembly off a second generation F-body fit the A-body cars?

Thanks
KFD