I have a Rivvy steering wheel/column sitting on the floor - I'll go see if I can figger it out
later
Butch
How do i remove and install the turnsignal bar to replace the washer pump switch.paul
I have a Rivvy steering wheel/column sitting on the floor - I'll go see if I can figger it out
later
Butch
Paul, is the washer activated when you pull in on the turn signal bar, or do you twist it?
on the rivvy, I think it only worked if you pulled back on the bar - that being the case, the switch is actually on the steering column, just above the ignition lockout switch. on the rivvy, a rod runs down the column and moves a spring loaded switch. the switch comes off by removing two 5/16ths head screws.
hope this helps
Butch
Bookmarks