say Bob, you never do mention a spec for the overall length of the piece of stock you use for each control arm.
what would that be, 24"?
the upper arm is 11" from center to center. it's a bit more involved than the lower arm. the wide end is 2 7/8" across the inside and only 1 3/16" across the bushing end.
lower is 22", just as in Bob's fabrication project:
http://www.teambuick.com/forums/view..._trailing_arms
The way to crush the bourgeoisie is to grind them between the millstones of taxation and inflation.
Vladimir Lenin
Government schooling is about "the perfect organization of the hive."
H.H. Goddard, Human Efficiency (1920)
say Bob, you never do mention a spec for the overall length of the piece of stock you use for each control arm.
what would that be, 24"?
The way to crush the bourgeoisie is to grind them between the millstones of taxation and inflation.
Vladimir Lenin
Government schooling is about "the perfect organization of the hive."
H.H. Goddard, Human Efficiency (1920)
Mmmmmmmm.....
It would look like I allowed about 1/2" beyond the bushing.
WEBNOTE: When inserting an email in a posting, use the "smilie" @ so that web robots don't pick up your address and send you more junk mail!
Members can be contacted by clicking on their "handle", but you are much better off to post to the thread!
so, iz what yer tellin me is, you don't really know how long of a piece i need to buy?
The way to crush the bourgeoisie is to grind them between the millstones of taxation and inflation.
Vladimir Lenin
Government schooling is about "the perfect organization of the hive."
H.H. Goddard, Human Efficiency (1920)
Bookmarks