The engine is a small block. You don't have to change anything but the intake and carb to make it a "350-4". Unbolt your existing 2 barrel intake, clean the sides of the heads and the valley rails, install a new gasket and properly tighten down the 4 barrel intake and install the carb, modify the fuel line and go. Obviously you will need a 4 barrel air cleaner. It would be nice if you could come up with the quadra jet that came on the intake from the factory so that you wont have a lot of problems with the choke and throttle linkages. Job should be a piece of cake. Good luck.
Bookmarks