I want to change from bolts to studs. I have seen some screw in studs in the past, but now can't seem to find them. Does any one know who makes them? I think the rear hub takes 5/8". I did a front disk conversion, and the front studs are 1/2". If possible I would like to find studs that have 5/8" for the hub and 1/2" for the wheel. The wheels that are going on are a set of vintage "Uni-Lug" mags that are @ 1.5" thick.
Jason
Weird is relative and my relatives are weird!
5/8"... it must be that cheap crack...
9/16" bolts. I found NAPA #641-2156 studs that will require a little boring out of the threads and hammering in from behind. They are 1/2" thread and 2" long.
Jason
Weird is relative and my relatives are weird!
Bookmarks