There is a jumper connector for the fuel pump taped to the wiring harness on the dr. side , it is a single red wire and black plug with a flat spade terminal and you and use a fused jumper wire to apply battery voltage to the fuel pump (This is the test connector from the factory ) the fuel pump should run if not take a rubber hammer and tap the center of the fuel tank ( this is where the fuel pump is ) Hope this works , I have done this to get cars in the shop , also the pump will work until you cut the car off so remember to plan your trip. Good luck !
Guyopel
The early bird gets the worm but the second mouse always gets the cheese.
Bookmarks