From the Reference Section:
- Carter Dual 4-Barrel Carburetor Idle Adjustment
- Carter Dual 4-Barrel Carburetor Adjustment
- Carter Dual 4-barrel Carburetors, Linkage Sticking
- Buick Cam Specifications for 401 and 425 nailheads
- Buick Cams from Kenne Bell, 401, 425
    - Nailhead Engine Specifications
- Head Flow Chart
- Nailhead Oil Pump
- Nailhead cam specs and cam selection
- Nailhead Parts Interchange
Results 1 to 3 of 3

Thread: Crankshaft counterweight groove

  1. #1
    Join Date
    Aug 2005
    Posts
    19
    Rep Power
    0

    Question Crankshaft counterweight groove

    I have my 425 torn down and noticed a groove on the crankshaft counterweight just above the oil pump. The patina on the groove makes it look like it was freshly cut. But there was nothing obvious to indicate failure induced wear. There is less than 1/4" clearance between the counterweight and the pump mounting bolts. The bolt heads show no wear. Is this a designed machine clearance to clear the pump bolts or do I have an interference problem (loose bolt?) that created (wore) the grooves? FWIW the pump was replaced due to failure before I owned the vehicle but I don't know how catastrophic the failure was. I don't know if I need to address this issue before continuing with the rebuild. Any advice?

    Thanks in advance for your input

    Jim

  2. #2
    Join Date
    Aug 2005
    Posts
    700
    Rep Power
    0
    Check your crankshaft end play.
    Guyopel
    The early bird gets the worm but the second mouse always gets the cheese.

  3. #3
    I don't remember if that groove was put in by the factory but even if it was worn in by the old pump bolts if you have the crank magnafluxed and balanced it will be ok.
    Jim Carmichael 55 Buick Special & 65 Buick Riviera GS

Similar Threads

  1. 1975 455 3 groove crankshaft pulley
    By Kran in forum New Member Introductions!
    Replies: 2
    Last Post: 09-13-2015, 07:23 AM
  2. 264 Crank Pulley 2 groove
    By dunda in forum New Member Introductions!
    Replies: 4
    Last Post: 07-07-2015, 08:48 AM
  3. 1955 buick special 264 v8 groove pulley & harmonic balancer
    By darchmo@aol.com in forum Nailhead: 264, 322, 364, 401, 425
    Replies: 2
    Last Post: 08-14-2011, 04:22 PM
  4. in need of a '53 322 single groove cast crank pulley.
    By starboy750 in forum Nailhead: 264, 322, 364, 401, 425
    Replies: 3
    Last Post: 03-16-2010, 08:11 AM
  5. Need a 3 groove '63 401 crank pulley
    By old28 in forum Nailhead: 264, 322, 364, 401, 425
    Replies: 0
    Last Post: 11-17-2009, 10:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
TeamBuick.com Privacy Policy