BEARINGS, seals for: axles, clutch, differential, pinion, transmission, wheels, all years. Olcar Bearing Co, 135 James Creek, Southern Pines, NC 28387, 910-693-3324.
Type: Posts; User: Flynbuick
BEARINGS, seals for: axles, clutch, differential, pinion, transmission, wheels, all years. Olcar Bearing Co, 135 James Creek, Southern Pines, NC 28387, 910-693-3324.
If OH it should be a 3.42 ratio non posi rear with a 3 or 4 speed manual trans.
I think most makers had the dimples in the floor pans for the anchor points beginning in 62 or 63.
http://www.chevelles.com/forums/showthread.php?p=982562
Whenever you see the words "Only surface rust" beware because no there is rust especially if it has ever lived outside. Look at it from the bottom side up and the inside out.
Bigger Buicks are...
Contact www.espo.com for replacements.
They were available on a 64 Sports Fury so yes they were on some 60s cars.
Very close to the same period Vette wheel. If you want black buy it from www.thepartsplaceinc.com or Zip corvette.
Well yes and no. By your statement all Buick models made in 64 were 4000 series. I think intuitively you must see that is not the case and it would make little sense if they were. By the 65 model...
For a disc try www.napaonline.com
For a conversion try www.scarebird.com
Just one repalcement disc or a whole conversion kit?
Once they have been broken in on leaded fuel I do not htink you will see any issue runing today's fuel. If it makes you feel better mix in some 100LL avgas once in a while. It is a lot cheaper than...
In 64 I believe you have a 9 3/8" just like Rivieras, Electras ect. I think the LeSabre that year is a 4000 series car and the Wildcat is a 6000 series. There are no aftermarket gear sets for a 9...
Hood and hood lip molding are different.
Used is your only choice for those.
Look at the top of this screen and click on "community".
"...I'd like to go with a 15, something like a 245/60/r15 on the rear and something like a 215/70/r15 up front.any thoughts?"
If you have a posi rear end and a flat tire you are are screwed...
This is a common misconception at increased rpms because of the inherent increased time it takes to create the magnetic field on the primary side and collape the same so as to induce the potential...
I believe an Ala tilte comapny is under investgation now in NC DMV and a defendant in a state suit brought by Cal. I would ask them if they are that defendant. I beleive NC may be combing their...
63 LeSabre low compression 401 engine has a 2 barrel carb.
I beleive they are only a 64 year item.
I beleive Sanderson makes shorties which for street cars with mufflers yield the same additional power.
www.Sandersonheaders.com
You are not going to reach your power goal for that kind of money. The 550 hp engine Bob referenced cost about 15K to do. You could get that with a Buick 455 for one half the price.
Boring for...
There is no hotter spark. If a plug is set at a given gap near stock the electric potential across the electrode will ioninize the air and a spark will ensure around 15K volts. As for whether a coil...
ST 400 trans.
If you will post a pic I can help you.
Mike Trom can do the sticker for you.