Search:

Excuse me if i sound like the devil's advocate or way too pragmatic here, but whats the difference? GM cars are all the same now except for a few differences in trim and styling. If they eliminate...

we could tell you how to change the maf sensor on your engine, but it's quite possible something would get lost in the translation, possibly making the situation worse.
Go to a parts store and buy a...

Im going to go out on a limb here and sugest that the problem is your transmission range sensor.
To my knowledge, it is the only switch directly connected to the shifter linkage and controls a whole...

where's it leaking? if it's coming out of the vent hole then you could have water in the trans. fluid. this would probably be from a bad cooler unit inside the radiator, and thus getting cycled into...

200 is a little hot for any motor to be running, you could start getting dieseling(run-on) and backfiring problems. It could also cause the fuel-air mixture to ignite prematurely causing knocking and...

the optimal running temperature for all vehicles is around 88* celcius. this promotes better emmisions and allows the fuel/air mixture to burn more completely. this translates into about 180-190*F.

go to superchips.com for an ECU programmer.
as for headers, try www.clearimageautomotive.com.
i've heard their headers are pretty good, however, they might not make a set for FWD.
as for the...

i have the service manual for my 71 skylark, and i would assume that the alignment specs are the same for a 72, so here goes.

caster between: -1* and +2*
camber between: -1* and +2*
toe in:...

get a continuity tester and a circuit diagram, that'll be the easiest way to test that.
you could also have a bad ingition switch or some other wiring anomaly which could be much harder to track...

you may also have an issue bolting the Torque converter to the flywheel, GMs use 3 nut and bolt fasteners and fords use 4 bolts that go through the flywheel into the torque converter.
you may also...

i think it's carburated, from what i recall 88 was the last year for carbs before TBI.
if im right, then you probably just need to give the motor some TLC. A tune up, reset the timing and...

put in on what motor?
you need to make more sense in your posts!

i don't think they made one for that year... i can't think of any GM that had that motor with a manual trans.
maybe one from a camaro's 305 will work if you change out the starter as well.
i'm...

i think the definition of the word has been forced to change due to the ever-shrinking supply of original parts, and the rising cost of OE and aftermarket replacement costs. I for one cannot for the...

this problem is common among 80s GM steering columns. it's a pain to repair yourself, but is do-able if you have a whole afternoon and the right tools.
here's a link to a site which sells the kit:...

shouldn't have a problem with the transmission. the supercharged 3.8s still use the 4T65E and once the new PCM is installed, it will change the shift points and firmness as necesarry.

you won't be able to use the 350 oil pan for your conversion, or the driveshaft.
buick put 455's in skylarks that year, and you should be able to find one from poston, year one, or TA performance....

why doesn't the chevy motor fit? if it won't bolt up to your transmission, then i would recommend using the trans that is in the celebrity. if it's a motor mount problem, then you *should* be able to...

for your door lock, take the door skin off the door frame and take a look at all the linkages, it should be fairly obvious which part isn't working the way it should be.

-Ben

coolant leak perhaps?
is the car leaking anything onto the road?

it should fit, but honestly, the 2.5 is one of the worst 4cyl engines ever made, the "iron dog" they used to call it. those motors leak oil like nothing i've ever seen before. if you can find...

I've got the same problem here, no graphics at all show up on this site! It started about a month ago.
What's the deal?

the 3.8 is generally a very solid motor. however, since this motor sounds like it's never really been touched, I would look at a rebuild. If you're getting a lot of blow by in the PCV system then i...

going by what you've said, your water pump sounds like it's working perfectly.
Yes, water should be running in the radiator once the engine has warmed up and the thermostat has opened - but not...

First, I would buy a haynes/chilton manual for your car, most of them have sections on radio or dash component removal.
Since your car's a 94, you have the "newer" style of GM radio i believe. These...