If the fluid is low, you have to bleed air from the system. Most 3.1s have two bleeders, one on each side of the engine. One is near the coolant pump, the other near the upper hose outlet. Hope this...
Type: Posts; User: chrisj
If the fluid is low, you have to bleed air from the system. Most 3.1s have two bleeders, one on each side of the engine. One is near the coolant pump, the other near the upper hose outlet. Hope this...
Measure from the floor to the bottom of the fender opening. Make the measurement through the centerline of the tire. Front is 29 inches, rear is 21.5 inches. Unless its at least an inch lower I...
Either your input gear bearing is bad or the new cluster gear and old input gear aren't meshing right. My $ is on the input bearing. Hope this helps.
If it is acting up in forward and reverse, you might luck out and just need to change the filter. If it's acting up in forward only, its the forward band, input clutch, or 1-2 overrun clutch. My...
Instant failure usually means that a shaft has broken or there is some other mechanical failure. If the oil level doesn't change, I would suspect the oil pump drive shaft is broken. The pump is...
Sounds like hard or broken seals on the input clutch. Unfortunately this means that the transaxle will have to come out. You may as well try a can of seal sweller stuff before having it overhauled,...
Depends on where your starter is mounted. If the starter is mounted on the engine, you should be able to find a Turbo 400 that bolts in. If the starter is mounted to the transmission bell housing,...
Can anyone tell me what the following 1993 Roadmaster Service Parts ID (RPO) codes mean?
DFG (maybe a mirror option?)
WRN
Thanks