has anyone tryed to put a 454 bbc motor in a 1962 buick lesabre ?? and will it fit??
Type: Posts; User: jr2012
has anyone tryed to put a 454 bbc motor in a 1962 buick lesabre ?? and will it fit??
ok when i turn the key the gen light is on and stays on with the car not running,now if i start the car the light will go out but will come on dim and go out i put a new volt regalater in and still...
ok think i may have found it on outside under hood going in to fuse box the is two plugs and one black wire next to the back wire is a large red wire
i played with that red wire i get power is the...
i played with the wires going in to the fuse box under the hood the power came on the car started it ran with the door open for 15 min then
the the car shut off now no power i pulled the wire to...
I got no power to key no lights or anything .i am going to get new battrey on monday.iam going to kick my *** if thats it,i tried everthing but battrey
checked all wires under dash and under...
cables good,starter link good.still no power checked all fues put test light it fuesbox no power no lights in or out no radio.wipers heater
*** is up with this car horn works lol:angry:
62 BUICK LESABER need some help started my car today it was running opened the door and the car shut off i have no power inside the car at all radio.domelight
dash all fuse good no headlights turn...
I have a 1962 buick lesabre and i can't get the clock to work i get power up to it.i just picked up a sec one and can't get that one work.anyone know how to
fix it?? or what wrong whith it:confused:...
i don't want to run stock air cleaner.i pickup a carb on ebay it a carter afb 3503 that for 60 to 62 buick and i found a rochester 60 62 buick.what one would you run ? and can i run a after market...
can someone help ?? i have a 1962 buick 401 nailhead will new topend ta-112 cam & lifters pushrods.timing chain and gears
new set of rockers setup.going from a 2bbl to 4bbl what carb will be the...
thanks for the info,found the oil whole in the rocker bolt wholes thay where cloged up with slug:thumbsup:
the cam is a hydraulic,but there is no holes in the push rods
i am new to this 401 nailhead engine.how does the oil get up to the rockers .the push rods have no holes in them:confused:,.i putting a new TA 112 cam & lifters.push rods timing chain.full set of...
anyone running the TA20 camshaft or the RV12 ????:waving:
tom what size cam do i go with on a stock 401 nailhead.do u have any ??
ok i want to put a new cam and lifters in my 62 buick lesabre 401 whats the best cam setup??. and what is the stock cam spec..thanks Rich
thanks Ray.i am going to pull the motor out and fix it.i talk with Tom Telesco at
Classic and Muscle Automotive and have him do the motor fresh it up.i think after 50 year it may need some...
ok started doing the water pump on my 62 buick the first two water pump bolts broke one to the housing and one that go's into the block.so now i stopped and spradyed the bolts with PB blast and it...
it has 104,659 mil, thanks Rich
i have a 1962 buick lesabre 401 nailhead when i start the car i have 40lb oil pressure .then it drops to 20lb when i drive it stays around 20lb.at a light or stop i get 30lb...it has dropped to...
thanks, i got a pump at autozone for 56.00..:hurray:.i only use the car on the weekends for shows.do you know where the best place to buy nailhead parts or to find 62 buick parts..thanks Rich
hi i need help with this one. my 62 buick lesabre 401 nail head.ok when i got the car it had a 7lb cap on the radiator.the book calls for a 16lb cap so i picked one up.and put it on .and water came...
HEY whats up.i had fun tring to find part.i found a lot on ebay.i got the same trans and got a kit on ebay they where grate to work the kit was 139,99..now for parts www. cars inc .com they are in...
i got a shop to do the trans for 300 and i buy the parts so the cost is 450.:bana:
it is atf, I found the kit on cars inc to do the trans for $195 + tax. now i have to find someone to do it .thanks Rich