That does make perfect sense. Thank you again to everybody. :shifter:
Type: Posts; User: 19RivyRob68
That does make perfect sense. Thank you again to everybody. :shifter:
:wavey:
Thank you Randy and Sean. and referring to 'P' luggage light......it does have a trunk light and inside it has a switch for courtesy lights so maybe it is for Courtesy Lights.
RivyRob
11B F
ST 67 - 49487 EUC 70571 BODY
TR 664-B VV PAINT
2GR
...
:waving: i would check choke but actually, give it a full tune up. the timing for the 72 specs are different then the 67-9 specs. when cold, take off air cleaner lid, now give it one full...
:bana: sound like the trap door is not going to full heat--- locate it and watch it as you adjust it from cold to hot then see if it can go further in travel---probably a vacuum line...
:wavey: im just curious why you want to use a different starter. Is it because it is having problems or noises---why not rebuild your starter yourself---or take your starter off and take it in for...
:confused:hey
so is your engine getting hot(normal operating temp) about 195 degrees farenheight? do you have a temp light or actual guage? after its been running for 30 minutes--- is the top...
:confused:Need more information.......is your engine getting hot(check thermostat)....is your trap door working for cool to heater.......do you hear vacuum as you move the control from defrost to...
If it was full when you started it, then you have a leak somewhere, or a head gasket leak, maybe your thermostat stuck and caused a boil over. Fill it up, check for leaks, start it, let run till...
How's the water/antifreeze level? Have you let it cool, added water and re start it? more to come after these answered.
Rob :waving:
:waving:
You look like a young guy, I just thought I would give you a tip....If you need to roll your car around, just get an old broomstick or 2X4 and then a couple of longer bolts and put...
Hi,
Well, the first thing you have to decide is how much money do you want to put into your 'Power Project'. You cannot use '70 heads as the water jackets don't line up.
The first...
my best advice to you is to get yourself a chassis manual book for your car an original by GM . they are most invaluable for knowledge of this kind. Happy New Year!!!
Rob
change flasher and get back to me
Let's first address the signal staying 'on'. These are notoreous for breaking as yours is. The only way to fix that is to replace the whole switch. Do you have cornering lights? if you do , it...
so with the ignition in the on position(you can have the engine running or not)actually, do not have the engine running so you can hear the flasher. OK, so with the ignition on, hold the lever all...
:waving:
Hi;
you have one or more bulbs that need to be replaced on that side and/or the ground for one or more bulbs need to be repaired.
Hope that helps ya!
RivyRob :wavey:
Hi Fellow 68er
Yes, it does sound like the Accessory fuse breaker. The thing I would check is to make sure that the power seat controls are in their neutral position. Sometimes they get sticky...
You're very welcome! Just to continue... since the car you are putting it in has the std gears in rear end then for sure you will be able to use any brackets and pulleys off of any full size...
It is an alternator...not a generator. I'm wondering why you may think they are not. The alternators in those years are physically the same size---they just have different amp ratings--a car with...
So, if I am to understand you correctly, you put a 1971 455 engine (from a non GS car) into your 1972 455 GS car. Well all of the brackets and pulleys will be the same except in a vehicle that has...
:waving: Did the shop do everything---like you took your Riv there and they removed/rebuilt/re-installed it? if so, I'd be making them fix all the problems to your satisfaction or take them to...
and dont forget to put the fan back to how it was, the original installer had it correct----the airflow is from the front of the car to and through the rad then towards engine. Light a cigarette...
I should say it is running warm.....water passages in those heads DO NOT match the passages in the block---I'm surprised that it isn't leaking!
Back to your question.....I don't understand your...
HI
How about turning the idle up a bit --- what do you have it set at?
Rob