Search:

Type: Posts; User: Flynbuick

Page 1 of 16 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    1,437

    BEARINGS, seals for: axles, clutch, differential,...

    BEARINGS, seals for: axles, clutch, differential, pinion, transmission, wheels, all years. Olcar Bearing Co, 135 James Creek, Southern Pines, NC 28387, 910-693-3324.
  2. Replies
    5
    Views
    1,242

    If OH it should be a 3.42 ratio non posi rear...

    If OH it should be a 3.42 ratio non posi rear with a 3 or 4 speed manual trans.
  3. Replies
    5
    Views
    1,082

    I think most makers had the dimples in the floor...

    I think most makers had the dimples in the floor pans for the anchor points beginning in 62 or 63.

    http://www.chevelles.com/forums/showthread.php?p=982562
  4. Replies
    3
    Views
    720

    Whenever you see the words "Only surface rust"...

    Whenever you see the words "Only surface rust" beware because no there is rust especially if it has ever lived outside. Look at it from the bottom side up and the inside out.

    Bigger Buicks are...
  5. Replies
    8
    Views
    2,543

    Contact www.espo.com (http://www.espo.com) for...

    Contact www.espo.com for replacements.
  6. Replies
    6
    Views
    1,413

    They were available on a 64 Sports Fury so yes...

    They were available on a 64 Sports Fury so yes they were on some 60s cars.
  7. Replies
    1
    Views
    869

    Very close to the same period Vette wheel. If you...

    Very close to the same period Vette wheel. If you want black buy it from www.thepartsplaceinc.com or Zip corvette.
  8. Replies
    4
    Views
    1,129

    Well yes and no. By your statement all Buick...

    Well yes and no. By your statement all Buick models made in 64 were 4000 series. I think intuitively you must see that is not the case and it would make little sense if they were. By the 65 model...
  9. Replies
    3
    Views
    2,637

    For a disc try www.napaonline.com...

    For a disc try www.napaonline.com

    For a conversion try www.scarebird.com
  10. Replies
    3
    Views
    2,637

    Just one repalcement disc or a whole conversion...

    Just one repalcement disc or a whole conversion kit?
  11. Replies
    4
    Views
    822

    Once they have been broken in on leaded fuel I do...

    Once they have been broken in on leaded fuel I do not htink you will see any issue runing today's fuel. If it makes you feel better mix in some 100LL avgas once in a while. It is a lot cheaper than...
  12. Replies
    4
    Views
    1,129

    In 64 I believe you have a 9 3/8" just like...

    In 64 I believe you have a 9 3/8" just like Rivieras, Electras ect. I think the LeSabre that year is a 4000 series car and the Wildcat is a 6000 series. There are no aftermarket gear sets for a 9...
  13. Thread: Help

    by Flynbuick
    Replies
    2
    Views
    743

    Hood and hood lip molding are different.

    Hood and hood lip molding are different.
  14. Replies
    1
    Views
    763

    Used is your only choice for those.

    Used is your only choice for those.
  15. Thread: Navigating

    by Flynbuick
    Replies
    4
    Views
    1,493

    Look at the top of this screen and click on...

    Look at the top of this screen and click on "community".
  16. Replies
    15
    Views
    1,699

    "...I'd like to go with a 15, something like a...

    "...I'd like to go with a 15, something like a 245/60/r15 on the rear and something like a 215/70/r15 up front.any thoughts?"


    If you have a posi rear end and a flat tire you are are screwed...
  17. Replies
    17
    Views
    3,090

    This is a common misconception at increased rpms...

    This is a common misconception at increased rpms because of the inherent increased time it takes to create the magnetic field on the primary side and collape the same so as to induce the potential...
  18. Replies
    4
    Views
    1,201

    I believe an Ala tilte comapny is under...

    I believe an Ala tilte comapny is under investgation now in NC DMV and a defendant in a state suit brought by Cal. I would ask them if they are that defendant. I beleive NC may be combing their...
  19. Replies
    4
    Views
    896

    63 LeSabre low compression 401 engine has a 2...

    63 LeSabre low compression 401 engine has a 2 barrel carb.
  20. Replies
    3
    Views
    792

    I beleive they are only a 64 year item. I...

    I beleive they are only a 64 year item.


    I beleive Sanderson makes shorties which for street cars with mufflers yield the same additional power.

    www.Sandersonheaders.com
  21. Replies
    24
    Views
    5,144

    You are not going to reach your power goal for...

    You are not going to reach your power goal for that kind of money. The 550 hp engine Bob referenced cost about 15K to do. You could get that with a Buick 455 for one half the price.

    Boring for...
  22. Replies
    17
    Views
    3,090

    There is no hotter spark. If a plug is set at a...

    There is no hotter spark. If a plug is set at a given gap near stock the electric potential across the electrode will ioninize the air and a spark will ensure around 15K volts. As for whether a coil...
  23. Replies
    3
    Views
    1,441

    ST 400 trans.

    ST 400 trans.
  24. Replies
    2
    Views
    923

    If you will post a pic I can help you.

    If you will post a pic I can help you.
  25. Replies
    5
    Views
    1,792

    Mike Trom can do the sticker for you.

    Mike Trom can do the sticker for you.
Results 1 to 25 of 390
Page 1 of 16 1 2 3 4
TeamBuick.com Privacy Policy