Search:

I put a video of my 1941 Buick radio on Youtube at this link.http://www.youtube.com/watch?v=BHnRQllC-wA
It gets more stations and sounds better than most new radios.

My 1940 Buick Super is now running and driving. Thank you for all the help I received from members and the archives. Here is a link to a video I posted on YouTube: ...

Thank you for the information. I ordered the Parts from Bob's Mememorabilia. I hope I can do this.

I need to replace a rear wheel bearing on my 1940 Super. I have a shop manual, but I can't find the procedure.

1. Should I first remove the wheel and brake drum?
2. If I have to remove the...

What vehicle are you planning to put this engine in? I have a 1940 Buick with an original 248 straight eight. It runs as good as the brakes and suspension will handle. If it had muchmore power I...

Your photos and car look great. Thanks

Put the Buick in first gear, hold down the clutch, have someone push your car, then pop the clutch. That is how many cars were started. Put a mark on the crankshaft pulley and see if it moved.

Thank you.

I installed an original combination fuel and vacuum pump on my 1941 Special engine. But, I do not know where the vacuum pump lines go. Does the front line go to the wiper motor? And, where does the...

The frame was from a 1941 Special. The back of the frame had been cut off when I got it. I bought the frame because it had an engine which was not frozen like mine. After getting the drivetrain...

I have been testing a 1941 drivetrain on an open chassis getting it ready to install in my 1940 Super. My wife took a video of me driving it, and I put it on You Tube. Here is the link. It is not...

Jerry, You took the head off. Can this be done without taking the head off, and just lifting the engine by the rocker arm shaft? That is scary. It is hollow so the oil can navigate.

I plan to install the engine, clutch, and transmission from the 1941 sitting on the chassis as one assembly, into the 1940 Buick. I am not sure how to lift it. There are 3 holes at the corners of the...

Your making me sorry I sold them. I had the manifolds on one Ebay listing and the carburetors on another and they sold today.

there is no external resistor in the 6 cylinder Buick coil circuits. I sent a link to a wiring diagram to you.

The rear carburetor wasn't really designed to do much. It did not have a choke or accelerator pump. It just idled until you put the gas pedal all the way down or went at a very high speed. I thought...

I never got my stuck engine free in my 1940 Super. So, I bought a 1941 drivetrain on a chassis. I removed the compound dual carburetor set-up after I got that running good, then replaced the...

Affsheen52, Where are you? Harry at 727-787-6392

I think I will wait another week and let my strange brew of transmission fluid , PB Blaster, Marvel Mystery Oil and Coke do a little more work. I...

Wildcat68, I really appreciate that offer, but it is too far for me to travel. I am in Central Florida, probably 1000 miles away.

I cannot do it myself. I will try to find a garage that does it, and get an estimate. I didn't think mechanics did that anymore. I thought they just installed remanufactured engines.

I am looking for a running 248 for my 1940 Buick Super. I would really appreciate any information on locating one and what they are worth.

My engine is frozen. I have tried PB Blaster, Marvel...