Search:

Type: Posts; User: WildKitty

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    30
    Views
    6,857

    T-400 and other Buick stuff

    I've had a lot going on the past six or so months and haven't had time to chit chat
    about Buicks or other stuff.
    Old age is creeping up on me with vegence, can't do all the things I used to, and...
  2. Replies
    5
    Views
    1,328

    There is nothing "unoriginal" about putting power...

    There is nothing "unoriginal" about putting power brakes on a 1969.
    My 64 LeSabre came with power brakes.
    I put disc brakes on the front of the LeSabre, so I did have to install
    a partitioning...
  3. Replies
    11
    Views
    2,151

    I just installed a Pertronix ignition in my 64...

    I just installed a Pertronix ignition in my 64 Wildcat 425. the Pertronix coil
    DOES take the full 12V.
    The relay Pertronix sent was a piece of crap made in China. I rewired the
    Wildcat with 12...
  4. Replies
    1
    Views
    647

    the lower windshield chrome molding clips are...

    the lower windshield chrome molding clips are mounted in the holes.
    the clips that hold the windshield in place (on my Wildcat)
    slip over the weld, then the gasket fits over it. this might
    have...
  5. Replies
    10
    Views
    2,670

    you should have a purple wire going from the...

    you should have a purple wire going from the ignition switch to the starter selinoid and a yellow wire from
    the starter selonoid to the coil.
    the ballast resistor or resistance wire is not required...
  6. Replies
    5
    Views
    1,328

    I just installed a power brake booster on my 64...

    I just installed a power brake booster on my 64 Wildcat.
    no big changes, I had to drill a couple holes I the brake bracket
    and make a new MC to brake line connector. I got the booster
    out of a 94...
  7. Replies
    5
    Views
    826

    I put a PertronixII in my Wildcat 445 (425),...

    I put a PertronixII in my Wildcat 445 (425), removed the dist to make it easier.
    slid it right back in and fired it up. sure starts easy.
    will do the same with the leSaber's 300; should be easier...
  8. Replies
    3
    Views
    993

    Had same problem with ignition switch on my 64...

    Had same problem with ignition switch on my 64 Wildcat - chased my tail for a day trying
    to diagnois the problem. same symptoms; turn key to acc and she tried to start
  9. I wonder if Wheatbelt Buick, in Oklahoma would...

    I wonder if Wheatbelt Buick, in Oklahoma would pull some off one of their Buicks for you
    I don't have their number offhand
  10. Replies
    1
    Views
    448

    If the Impala trim will fit, try "Impala Bobs" in...

    If the Impala trim will fit, try "Impala Bobs" in Arizona
  11. Oh yea, OK... I got some of those from somewhere...

    Oh yea, OK...
    I got some of those from somewhere - can't remember offhand, but when I went to use them found that they were too big.
    I saw an advertiement for nylon ones, can't remember where...
  12. When I had finished removing all the little push...

    When I had finished removing all the little push on 5/16ths nuts off all the tits, to remove the chrome
    on my 64 Wildcat, I decided I would find a better way of reattaching the chrome and letters....
  13. Replies
    0
    Views
    1,147

    Fuel Pressure for Carter AFB 4bbl

    I've installed a cheaper electric fuel pump on the Wildcat, feeds a 425.

    I just came across the Carter P60504, that has the filter - that mounts
    between the fuel tank and pump.

    The P60504 only...
  14. Replies
    11
    Views
    3,555

    Let's remember: A relay is there to protect the...

    Let's remember:
    A relay is there to protect the switch -
    electrict motors, starter, windows, electric
    locks, window motors, electric fans, etc.,
    take considerable more amperage than the
    14 guage...
  15. Replies
    6
    Views
    4,360

    Probably leakig i the lower corners of the rear...

    Probably leakig i the lower corners of the rear glass gasket.
    you just have to replace the gasket.
    I just did this with my 64 Wildcat.

    You should probably replace the trunk gasket as well.
    ...
  16. You can always just go this route ...

    You can always just go this route
    ...
  17. I just went thru all this s_____tuff. does the...

    I just went thru all this s_____tuff.

    does the starter turn over (fast) when jumped? - just use a screwdriver between the
    Large post the battery is connected to, and tyhe post the purple wire is...
  18. Replies
    15
    Views
    3,075

    YUP, totally confused:jeez:

    YUP, totally confused:jeez:
  19. Replies
    15
    Views
    3,075

    Too bad ya couldn't have tackled this problem a...

    Too bad ya couldn't have tackled this problem a few years ago; I moved out here from Eugene in 2008.
    I bought my 64 Wildcat (445) out of an estate sale in Calif - it had been garaged for 30...
  20. Replies
    10
    Views
    1,451

    did you pull the door jam switch (to the dome...

    did you pull the door jam switch (to the dome light)? that wire goes to the light switch and the ignition switch.
    I just did a complete wiring harnes replace and I had two (one from each of my 64s)...
  21. Replies
    2
    Views
    657

    I think for 72 it was still lap belts. Correct?...

    I think for 72 it was still lap belts. Correct?

    I might still have a set - I installed three point belts
    in both my 64s

    where are you located?
    Butch
  22. Replies
    15
    Views
    3,075

    You might also look for a cracked vacuum line....

    You might also look for a cracked vacuum line.
    those symptoms were what caused my to find a
    vacuum leak on my Wildcat 445
  23. Have you checked to see if you have a voltage...

    Have you checked to see if you have a voltage drain, and/or 12v going to the dist from the coil
    does the electronic ignition go through a relay?
  24. Replies
    17
    Views
    2,689

    when I rebuilt my 300, I used a kit to rebuild...

    when I rebuilt my 300, I used a kit to rebuild the oil pump - when I first fired it up I had 5-10lbs oil pressure; NOT acceptable.
    I checked the springs in the relief valve and found the spring from...
  25. Replies
    1
    Views
    1,207

    My understanding is electric water pumps are for...

    My understanding is electric water pumps are for strip or track - to gain that HP lost by the belt driven pump.
    NOT recommended for street driving.

    I was thinking about one for my 300ci in the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
TeamBuick.com Privacy Policy