May sound like a dumb question at first until you see inside my trunk ( its full of hydraulics and stereo amps and I can't see the floor) but I need to access the sender...is their an access panel in...
Type: Posts; User: 49FLAMER
May sound like a dumb question at first until you see inside my trunk ( its full of hydraulics and stereo amps and I can't see the floor) but I need to access the sender...is their an access panel in...
This may be of some help....My newly acquired 65 Riviera seat doesn't go backward or forward even though the moter spins...after analysis/inspection it would appear the drive gear in the motor...
can't you just change the whole thing to 12 ?
Thanks for the link for the bushes....unlike my Cadillacs etc the lower arm on these aren't like a A arm with a pin ... it looks like you pull the bolt out then drop the control arm then the...
The hydraulic suspension travels have seen the bushes on my recently acquired Riviera Paradise say goodbye so I need new ones....I think rubber rather than urethane ???? Where can I get these and any...
Rear wheel drive Buicks did not have an EFI till 1991 and then it was on the Roadmaster. Lesabre went FWD in 85 and was an EFI V6. I believe by 87 it became the 3800.
The 5.0 305 was a Chevy...
Gets you every time...I should have looked harder, my eyesite is starting to deteriorate now I am in my 50's. Thanks very much for that.
The wiring was a mess when I bought the car in from TX, it is...
Hi from Australia, I am rewiring my car but cannot get the indicators to work ( I do not have a wiring diagram ) to check the wiring in the column I need to remove the steel disc that engages the...
I have bought a 1950 that has a 305 injected v8 /th700 and the required wiring harness, which is a complete mess and a mile longer than it needs to be. Before I start hacking at it a wiring diagram...
I HAVE A 50 JETBACK HERE IN AUSTRALIA (IN FROM CA ABOUT A YEAR AGO ) NICE CAR TOO BUT BOY IS IT A PIG TO STEER IT.... PUTS ME OFF DRIVING IT. SLIGHT CURVES ARE OK BUT IT JUST DOES NOT WANT TO TURN......
I have purchased a 1950 buick with a 305 tpi/700r trans supposedly out of a 1985 Buick ( the chassis is an 85 park avenue I was told ) but I don't think this is correct...can anyone verify this. also...
Thanks for that, I thought about having to bore a large hole but this should do the trick, plug feels sound with my fingers ( can't see a thing ) so hopefully would come out complete.
It seems my starter's drive unit has failed, (the part that engages the flywheel with the clutches and gear )
does anyone know where I can get a replacement, as I live in Australia I cannot just go...
I don't really want to ask this question as I fear what the answer is.....
what is the easy way to replace this plug at the back of the head ?
Hi all, I have only had this car about a year and don't drive it a lot...I have noticed that a small amount of coolant drips from the bell housing ( its a manual) after returning home. I have looked...
I HAVE FORGED AHEAD AFTER MUCH THINKING, REMOVE EXISTING SHOCK (3 BOLTS ARE HARD TO GET OFF) HACK OFF THREADED SECTION OF HOUSING THAT RECEIVES FRONT BOLT THEN BOLT BACK ON WITH ONLY 2 BOLTS (THIS IS...
Did you insert the shock inside the coil?
This is my first post on this site, I am in Australia and have a 50 sedanette 2dr, I am in the process of replacing the King Pins and want to install telescopic shocks to the front while I have easy...
I have just joined 'the team' to help me with my recently acquired 50, it is in very nice condition except for the shocks it seems..have removed the sway bar to fit new bushes and found that the car...