Search:

Bob's has all the Buick shop manuals. I found the Buick shop manuals for the '37 are very limited, I refer to my Motor's manuals for better, indepth information.

http://www.bobsautomobilia.com/

Thank you for your offer, a person on the AACA Buick site sent me the pages I was looking for.

Thanks again,

Bob

Does any one have a '41 shop manual? I would like someone to scan the section about installing and setting up the dual carb set up. I have '37 with a '40 engine and have just gotten a '41 dual carb...

I finally got the the dual carb set up.

I've been told I have the exhaust manifolds backwards. I also have the Y pipe.

I have another question, how different is the '40 engine/frame...

I'm not really looking for a high performance car, it's going to be pretty much stock but I thought it would be kind of cool to have the dual carb set up.

I want this car to be super quiet, just...

I just assumed the engines in the newer cars sat at an angle in the frame of the car. I bought the engine after it was taked out of the '40 Buick. Does the engine in the later cars sit at the same...

I have the chance to get a free dual carb set up from a '40-41 Buick. I have a '37 Specialty with a 248 I want to put it in. I have a '40 engine in my '37. When I installed the '40 engine I had to...

Here's what I'm doing. This is just the fitting stage. I'm using an old master cylinder and regular threaded rod. I have to get everything cleaned up and painted and then do a permanent installation....

Yes, I remounted it under the floor but because of the X brace I am mounting over and further back. I have residual valves for both front and back circuits. I don't think I will need a proportional...

Thanks for the information, I think I might have an answer. I also posted this on the HAMB board and have been told manual cylinders have a deep hole. The cylinder I have is listed by every parts...

I am upgrading the master cylinder on my '37 Biuck Special and want to use a master cylinder from a '70-72 Skylark. The one I bought was listed for a car with power or manual brakes. The question I...

I have my '37 Special torn down to the frame and now it the time to upgrade the master cylinder. I would like to know if anyone has information on a newer dual reservoir unit I could use to do the...

I bought a '37 Special last fall. It's a real bucket but I got it for $550, I figured I could part it out for more than that if I decided not to keep it.

The engine and tranny were junk, found a...