I just found your web site, I was having problems with installing a trunk seal so I went to the computer to look for help when I stumbled on this site. I installed a seal on the deck lid . I used a silicone product that was a pain in the *** to use it kept coming apart. So anyway it finally dried I tried shutting the lid but the seal was holding the lid up about 4". So I thought I might be able to adjust the lid well this didn't work either . I was in & out of the trunk a lot of times trying to see what the problem is. So I was not sure if I had the seal on properly. So I figured I would start all over. I removed the seal that was easy because it did not adhere to the rubber too good. This time I took the deck lid off & turned it over so I would not be fighting gravity. Next I need to clean up the metal surface on the lid. So hear is where I need some experienced help . 1 ; which way does the seal get put on and 2; what glue to use? Please help Mike in Pa.