I have a 67 skylark with a 4 speed shifter and I am looking for the boot for the short console with knee knocker tach. Is this a 2 piece unit and where can I get them.
Thanks
Dave
Printable View
I have a 67 skylark with a 4 speed shifter and I am looking for the boot for the short console with knee knocker tach. Is this a 2 piece unit and where can I get them.
Thanks
Dave
My car does not have a consul which should mean it takes the same boot. It is a single boot with a stainless trim hold down. I believe they are common to a-bodies a few years either side of '67.
Attachment 7898
1967 Buick GS shifter boot
https://rover.ebay.com/roverimp/1/71...1;CACHEBUSTER]
Buick 4 speed shifter boot retainer ring
http://rover.ebay.com/roverimp/1/711...1;CACHEBUSTER]
Cars with a consolette do use two seals. See attached exploded parts view.
The lower seal acts as a weather seal to the underbody. As noted by Bob, GM part no 3842926 is correct for '65-67 Skylarks with consolette, '64-66 Chevelles, and some '64-65 Olds F-85s. These seem to be readily available. Some sources indicate it may still be available from a GM dealer.
The upper seal clamps to the upper half of the consolette. The Buick part no is 1361008. Nothing turned up when searching by that number There are some aftermarket items available that look close to the original. Might be good to check fit of the new boot to the round shift lever. Some look like they are molded to fit a rectangular shaft.
Typical are:
CP1387S from www.thepartsplaceinc.com
Metro RP33Z from www.rockauto.com
SB652-3 from www.oldbuickparts.com
I am almost sure that the Shifter Boot is NOT the same for Non Console & Console cars.
The Buick Farm has the Boot for the Floor Shift Manual Trans with Consoles; https://www.buickfarm.com/component/...oducts&redform[1][tags][0]=45&redform[1][typeid]=1&redform[2][tags][0]=115&redform[2][typeid]=2&redirect=1
Doug