Hello,
Just finished rebuilding a 1964 Buick 300 .
I ran it on the stand to make sure there were no leaks .
I ran it three different times, but not more then 5min. each time
Now it is in the car and I am not sure of the proper break in procedure.
the ST 300 trans was also rebuilt , but it says in my book not to run the trans. fast .
How do I do this and yet break in the engine?
Just finished rebuilding a 1964 Buick 300 .
I ran it on the stand to make sure there were no leaks .
I ran it three different times, but not more then 5min. each time
Now it is in the car and I am not sure of the proper break in procedure.
the ST 300 trans was also rebuilt , but it says in my book not to run the trans. fast .
How do I do this and yet break in the engine?