Search results

Took apart my steering column to install a new blinker switch a couple years ago, in the process I broke the plastic cancel cam...well, I finally replaced it and now I can’t remember where the two wires on the horn contacts on the back of the horn button re-attach. Can someone show me a pic or...

Need some help I pulled the engine from my car...when I put it back in it wouldn't start, seemed like a dead battery so I jumped it and it started fine. A few days later it died on me and wouldn't start, it just clicked like the battery was dead but started just fine when I jumped it again...

I'm finally getting around to doing thee rear suspension on my car, I've noticed for a while that's it's of center. It's 1" over to far to the drivers side so the gap between the fender wells is different on both sides. I doesn't look like the rear end has have been messed with or taken out...

Hello everyone need a little help. So about a month ago I started and issue with my car not starting sometimes, I was like the car wasn't in park all the way so if I bump the gear lever up it would start right up, so I just figured I wasn't getting it all the way in park like I said. Well...

Hello All, I need a diagram that shows how all the vacuum lines connect to the heater control switches for a 70 Skylark. Thanks

I am in need of a good mechanic to help me figure out some issues I'm having with my engine. The car is a 1970 Buick Skylark with a 350 that has been toatally rebuilt and has less than 200 miles on it. I'm pretty sure that I'm either having carburetor or timing problems, maybe both. The carb...