Search results

Kiwijeff submitted a new listing: WANTED, Two 1966 Skylark trunk lid outer trim pieces, (about 4” long, pot metal); happy to pay ship - WANTED, Two 1966 Skylark trunk lid outer trim pieces, (about 4” long, pot metal); happy to pay ship View the entire listing here...

Kiwijeff submitted a new listing: Wanted, ‘66 Skylark trunk lid outer TRIM PIECES - Wanted, ‘66 Skylark trunk lid outer TRIM PIECES View the entire listing here...

Wanted 2 trim pieces outer bottom corners for 1966 Skylark trunk lid about 4" long with a curved shape; anything out there ? Also, need shipped at my cost to Taupo, New Zealand, thanks

Hi, mine is missing off my ‘66 skylark convertible. Is it one piece or three, If it’s three piece, I have a damaged main centre piece, but not the two outer edge bits with the curve, that I need; & if it’s a one piece, then I need one

Kiwijeff submitted a new listing: ‘68 Wildcat outer door handle, passenger side wanted - ‘68 Wildcat outer door handle, passenger side wanted View the entire listing here...

Hi all, I'm a Buick fanatic from way back; my '68 Wildcat HardTop I've owned for 27 years; (payed NZ$2,450 for it); my wife has owned her '67 Electra HdTp for 23 years, (both our everyday vehicles) I bought that on a trip to the States in 1996 for US$150 in Bakersville CA; I'm restoring a '68...

Hi all, I'm replacing the 300 cu.in in my '66 Skylark convertible with a 425 Nailhead & Switch Pitch Super Turbine 400. I'm in the process of rebuilding the 425 with a complete rebuild kit from T.A.Performance in Arizona, I've rebuilt the SP400 & fitted a Shift Kit. I've imported a rear sumped...

Hi there, I need a manual FLYWHEEL & PRESSURE PLATE for a 1965 Buick 300 cu.in V8, that I'm mating up to a 4 Speed T-18 gearbox & fitting to a Modified 1943 MB Willys Jeep; Anyone out there able to help me, & able to ship to New Zealand at my cost ? I have 5 Buicks, a'68 Wildcat...

Hi there all; Kiwijeff from down here in New Zealand. I have a few Buicks; my everyday driver (check my profile pic) is a 68 wildcat custom 4DR HDTP, I've owned this car for 22 years & have done all the work on her, including painting, (caravan too); My wife's everyday driver is a 67 Electra 4DR...

Hi all, I have a standard bore Buick 455 with .005" wear;Have sonic tested it, & it's proved to be a good sound block; Does anyone have, or sell, or know of +.020" forged or hypereurectic pistons,as I'd rather not waste boring out to +.030" & losing that much metal if I don't have to? Also...