Search results

# B12480203 spreadbore primary 1 7/16ths secondary2 1/4". Is this a BUICK intake manifold ? What year and motor(s). pulling my hair owt trying to find owt. Thanx in advance if you've helped. I kinda remembered someone telling me it was for the 430c.i. It weighs a ton.

Is there an aluminium intake that gives better performanc than than the oem high rise, a*r gap,long runners straight into the head. This seems like a good performance intake from the performance guys at Buick.

I'm thinking I'd like to put the 215 alum. V8 in my 67 Morris Minor 2dr Saloon, rather than one of my 455's which would be a lot more work. Anyone recommend a source where I might aquire said 215? I know if there's enough will & lots of money, just about any motor can be adapted to most any...

Is anyone out there using this manifold? Other than cool effect, is it a performance advantage better than a 4bbl? Is it more desirable than dual quads for performance

Found a couple of good looking Thermoquads at my local wrecking yard. I've never heard anything on using these on a BBB. I've only heard that they can be a good performance carb. Anyone care to share their experience/expertise ? Luv this site. So helpful and friendly. I like being associated...

what wires do I connect my stereo's red,orange,and blue wires to? Thought I knew. Worked in previous installation. Had a two page diagram of electrical system. Went to house to answer phone and came back to the car and the wind spirited off one of the pages. Found the one page about 75ft. away...

I have a 64 Riv w/a supposed "recent motor rebuild/overhaul".That's all the clown that sold it to me could tell me. I put an Edelbroc 600cfm vac 2ndaries on it's stock intake,tuned it up,Pertronics ignition,adjusted the shifter to go into low,put the switch pitch on a toggle switch.Car runs...