Recent content by ginuwine846

I am willin to purchase and pay for shipping to anyone who can help me locate a buick 340 4-barrel intake manifold...otherwise i will look into swapping out for a Chevy 350 engine...

The new harness (i put the connectors on the end just for troubleshooting The old harness Here's the connector end from the new harness that i cut off to fit for my vehicle harness My vehicle harness . Here the splices that were connected to my old switch. All i did was snip the ends and...

I have a 1966 Buick Lesabre Convertiable. I'm having a major issue with my wiring. I started off with a issue of "no brake lights" and "no rear left turn signal". I checked for fuses, they were fine. Checked all connections of sockets to housing, everything looked fine. the wiring is a "little...

To make a long story short, my steering is pulling hard to the left. I have almost destroyed 2 vogue tires because of this from " a feathering" effect on my tires. Ive taken the car to a alignment shop and they said my alignment is dead on considering the lift suspension on the car. I replaced...

due to my recent cooling issues on my buick 340, I bought a zirgo single 16in "3000 cfm" electric fan. Well its not living up to its name if u ask me or my engine so i'm thinking about upgrading to the lincoln mark VIII electric cooling fan. I've heard great reviews about these fans and not to...

Here's the situation, this engine was just rebuilt and at this point, has less than 120 miles on it. It has a new thermostat (what temp i have no idea since it was build out of state) the radiator "appears" to be fine with no restriction in flow, i just put a electric fan on it (a zirgo 3000...

Are there any BUICK mechanics in the Tampa, Brandon, Riverview area??? I just got my 1966 buick lesabre back from the shop and i could use a expert on showing me the ropes about the 340 wildcat engine thats installed along with other things. I will pay for your time and gas, I just want to learn...

I currently have what i believe is a ST300 tranmission bolted to my 340 engine in my 1966 Buick Lesabre Convertible. The transmission operates fine but i plan on putting larger rims on the car. (nothing crazy, just some 22's) I'm wondering will i have a issue pulling these rims with this...

THIS IS MY SECOND PROJECT. I HAVE A 1966 BUICK LESABRE WHAT I BELIEVE TO HAVE A 340 WILDCAT ENGINE BUT THE AIR CLEANER SAYS 350 WILDCAT. AFTER A WEEKEND OF CRUISING, AS I WAS PULLING HOME, IT STARTED MAKING A LOUD CLANKING NOISE AND ALL OF A SUDDEN THE HOT LIGHT CAME ON AND BEGAN RUNNING REALLY...

i just recently purchased a 1966 buick lesabre convertible. i want to replace all the speakers but i can't seem to figure out what size they are. can anyone help me?

welli put on the starter but none of the wires match, on the starter i noticed the large nut in the center and the two small thread and bolts on the side. can some one tell me the hook up for each connection. theres a s on the right and a r on the left of the starter silinoid

Ok, Got, Its Raing Right Now But When I Get A Chance I'll Hook It Up And Check Back O Make Sure Its Good

do anyone know how to connect a starter, when i bought my 1969 buick electra (430 engine) the starter was removed and the wires was just hanging, so i just bought a new one. thanks

i spent all day today trying to put on the damm oil pan on my 430 motor just to fail at the end of the day. i read my manual very closely but it seems like i just couldn't get the pan to go over the cross member, i swear i jacked the engine up, hell even the tranny to see if it would give me any...

thanks for the link, very much appreciated